non-standard indexable boring cutter  

non-standard indexable boring cutter With rough maching bore hole,removing the workblank remains in the bore
hole safely and quickly,and chamfering at orifices,it is ready to finish machining.
The design of indexable cutter structure and the use of PCD boring tool can
improve the processing efficiency and using life greatly,with high cost
performance More

non-standard indexable slot cutter  

non-standard indexable slot cutter With finish maching cutter transverse groove, it changes the
traditional mode of end mill machining around
circular .Precise cutter holder design, large
adjusting range, suitable for the workpiece of
different specifications in the same series,so you
don't need to change the cutter,but simply adjust
the changable diameter of cutter holder ,that
will reduce the switching type time and improve
the efficiency of machining.The PCD groove blade
with sharp and wearable cutting resistance of low
cutting edge will make the cutter more long life. More

PCD reamer  

PCD reamer With finish maching cylinder hole, it changes the traditional single-edge boring hole into
six-edge reamer reaming, using flange switching cutter handle, can overcome clients
defective workmanship,such as tool spindle jumping,no center out of the water,
and poor rigidness,can accord the roundness and cylindricity, aperture of bore hole
with the drawing,and can resolve the demand for customer efficient
craft.Cutting tool out of factory preset in dynamic equilibrium level
G2.5, in order to reduce the wear of spindle during high-speed machining,
and make cutting tool long life. More